Crankshaft Runout Question

[blethermaskite]

I think I would be pretty happy with that result, the chances of getting it any better are probably zero (sorry bad pun) well done. The next should be easier.....(well maybe)
Cheers, George

[themoudie]

This wee clip/reel from Facebook will no doubt give the heebeejeebees to some, but you get the idea!

Facebook_reel_trueing_a_crankshaft!

Good health to you all, BillR

[blethermaskite]

Hi Bill, saw that before......its 'great' There is another one on you tube somewhere with with a guy in his pajamas, wearing the safety flip flops, sitting in the dirt and beating the Bejasus out of a crank with a club hammer and checking for 'truth' with his finger nail! "sure it'll do rightly"
Cheers George

[themoudie]

Aye George,
At least the lass was using a good slug of bronze. Just hope it wasn't melted down from the diff' in the back of a Fordson Major! They are very good quality metal. Still snorkling in the east! Good health, BillR