Mototrans 250 (69mm bore) Cylinder Head needed; can you help??

[BamBam]

Hello
I have a Spanish 250 engine and the Cylinder Head has gone missing, presumed thrown away by accident during a workshop move!!

Does anyone have a suitable head to sell please?

The head is of course different to an Italian A series head; most easily obvious by the oil way spigot positioning and the recess for the cylinder liner top size of 89.95mm

[Eldert]

you need a bare cylinderhead or a complete one with everything including the bevelshaft and tunnel ?

Eldert

[BamBam]

Hello Eldert,

I would prefer a complete head with decent rockers and cam lobes (I have the Bevel Shaft and Tunnel); however I can source rockers and I have a cam that can be reprofiled if only a bare head is available.

Thanks very much for your help...

Paul

[Eldert]

Hi Paul

i will have a look today . i think i have a head with valves and valve springs laying around

get back to you later .

Eldert

[BamBam]

Any luck with the Spanish 250 Head Eldert?

[Eldert]

Hi Paul

i have a 69 bore cylinder head . its from a road dated 1976 . this is the head that has the little dome on top
for a little higher lift camshaft . comes with valves and valvesprings and the spring keepers .

exhaust threads are good and i will add a good fitting exhaust nut . sparkplug threads are good to .

price 150 euro plus shipping cost .

took some pictures this evening :

[BamBam]

Thats fantastic Eldert. Please let me know the inlet port diameter measured at the carb flange...

[BamBam]

If you have PayPal Eldert, just send me an invoice so I can pay you the total of150 plus shipping.
Thanks very much.
Paul

[BamBam]

Should have said, please send PayPal invoice to my email:
pb.ngn@btinternet.com

The shipping address is:
Paul Bamford
68 George Lane
Notton
Wakefield
WF4 2NJ
UK

[BamBam]

Hi Eldert,

I thought I had found a 24 Horras camshaft for the cylinder hed you supplied me but it was actually n Italian 250 camshaft and not suitable. Do you know of anyone who would have a 24 Horras camshaft or have the dimensions and profile so I can have one made up??

Thanks

Paul