WTB: Side Stand 66 Scrambler(NC) and plate mounts

[Adam]

Hi All

PO had removed the original side stand and welded a different stand on the frame behind the motor. I'm looking to correct this.

Duc3.jpg

Thanks

-Adam

[GT Wunder]

Adam,
Good looking bike! Wish I had your seat and rear fender for my old scrambler.
Is this what you are needing?
George T.

033.JPG

032.JPG

[Adam]

Hi GT
Close, I think. I do have a rustier version of yours. Is that off of your scrambler? I've attached an illustration of what I believe the plate mount is supposed to look like. Notice it does not have that wing that holds one end of the spring. I could be wrong.

9-14-2015 9-05-39 PM.jpg

[GT Wunder]

Adam,
Not sure what i'ts from, but appears to be the same as my '66 Scrambler and '65 Bitza ( M3 frame). It is the best one I have, and they all look the same. I'm sure the Scrambler's is original as I'm the second owner and I bought it in '72 . I'ts not rusty, but has been repainted in the past.
George T.

[Adam]

Hi George
Yeah, it's been a challenge for this year. Many of the photos I've seen are taken of the right side of the bike. Must be the 'good' side!
Is that one for sale? If so, how much are you asking?

Thanks
Adam

[GT Wunder]

Sent PM

[Adam]

Hi George
Just checking. Did you get my PMs?

Adam