Loose guide

[Bevel bob]

Hi Eldert, Would you consider using it to fix an inlet guide and replace a boss?.

[Eldert]

Hi Bob

i would weld the guidehole and machine a new hole but that is easy for me as i have al the jigs to do so .

Eldert

[Bevel bob]

Thankyou Eldert, I will take that Route , As you have done the job are there any tips you would like to pass on regarding the process? I notice that the rocker spindles were a sliding fit in the head , do you consider this an issue? I could refit them with a little locktite to stop them working in the alloy head what do you think?.