Scrambler parts needed
Posted: Wed Sep 21, 2011 5:49 pm
Restoring a 66' 250 N/C Scrambler, needing a few pieces still, please pm me with price or info, I have cash and/or a lot of spares, so im sure we can work something out...
Rear n/c Scrambler fender (any condition considered) mine is mangled, almost totally destroyed
aprilia 32150 key
aprilia 4 contact keyswitch, only need the upper collar/bezel, but would consider buying entire switch
66' scrambler battery tray, and or hardware ?? or exact , measurements, and detailed pictures of an all original one (i will pay for this) so i can fabricate my own that looks exactly like the original one
circut board/ and diode out of a early monza jr. or scrambler (not something you see, but if i can find one i would prefer to make my scr all original)
31.5mm front end parts needed
1 fork spring shroud (i have the l/h one with the loop already.
fork internals ( i have some, but they are kind of rough)
fork tubes ? anyone have decent ones, I am all set to order them from either frank, or guzzino... but I would rather not spend 300 on new ones if i can avoid it.
ANY HELP AT ALL WOULD BE GREATLY APPRECIATED, PLEASE DONT HESITATE TO PM ME INFO, OR PRICES...WORST I COULD SAY IS NO THANKS...
Side note to jason, and others waiting on pix of parts i have, ive been very busy the past few weeks, i intend to get on that very soon, its at the top of my agenda... thanks for your patience... Joe
Rear n/c Scrambler fender (any condition considered) mine is mangled, almost totally destroyed
aprilia 32150 key
aprilia 4 contact keyswitch, only need the upper collar/bezel, but would consider buying entire switch
66' scrambler battery tray, and or hardware ?? or exact , measurements, and detailed pictures of an all original one (i will pay for this) so i can fabricate my own that looks exactly like the original one
circut board/ and diode out of a early monza jr. or scrambler (not something you see, but if i can find one i would prefer to make my scr all original)
31.5mm front end parts needed
1 fork spring shroud (i have the l/h one with the loop already.
fork internals ( i have some, but they are kind of rough)
fork tubes ? anyone have decent ones, I am all set to order them from either frank, or guzzino... but I would rather not spend 300 on new ones if i can avoid it.
ANY HELP AT ALL WOULD BE GREATLY APPRECIATED, PLEASE DONT HESITATE TO PM ME INFO, OR PRICES...WORST I COULD SAY IS NO THANKS...
Side note to jason, and others waiting on pix of parts i have, ive been very busy the past few weeks, i intend to get on that very soon, its at the top of my agenda... thanks for your patience... Joe