FS Tank & Seat
Posted: Thu Jul 19, 2018 3:59 pm
I've got a tank and seat I don't need any more and need to find a good home. Make me an offer.
The tank is from a Benelli. I got it in pretty rough shape so I had it welded and sealed. It holds gas but there were two spots that had pin holes when I got it home. The inside has been sealed with POR-15 and the two spots got a glob of JB-weld. It'll still need some work. The petcock threads are good and I've got two extras one that go with it. The cap is not a correct cap but it works. The tanks is painted with a couple coats of primer.
The seat is not in too bad shape. There is some surface rust on the pan but that should clean up just fine. I'm not sure exactly what model it's from but it should fit a narrow case frame ok.
The tank is from a Benelli. I got it in pretty rough shape so I had it welded and sealed. It holds gas but there were two spots that had pin holes when I got it home. The inside has been sealed with POR-15 and the two spots got a glob of JB-weld. It'll still need some work. The petcock threads are good and I've got two extras one that go with it. The cap is not a correct cap but it works. The tanks is painted with a couple coats of primer.
The seat is not in too bad shape. There is some surface rust on the pan but that should clean up just fine. I'm not sure exactly what model it's from but it should fit a narrow case frame ok.
