Page 1 of 1
WTB: Side Stand 66 Scrambler(NC) and plate mounts
Posted: Mon Sep 14, 2015 4:41 pm
by Adam
Hi All
PO had removed the original side stand and welded a different stand on the frame behind the motor. I'm looking to correct this.
Duc3.jpg
Thanks
-Adam
Re: WTB: Side Stand 66 Scrambler(NC) and plate mounts
Posted: Tue Sep 15, 2015 1:56 am
by GT Wunder
Adam,
Good looking bike! Wish I had your seat and rear fender for my old scrambler.
Is this what you are needing?
George T.
033.JPG
032.JPG
Re: WTB: Side Stand 66 Scrambler(NC) and plate mounts
Posted: Tue Sep 15, 2015 1:31 pm
by Adam
Hi GT
Close, I think. I do have a rustier version of yours. Is that off of your scrambler? I've attached an illustration of what I believe the plate mount is supposed to look like. Notice it does not have that wing that holds one end of the spring. I could be wrong.
9-14-2015 9-05-39 PM.jpg
Re: WTB: Side Stand 66 Scrambler(NC) and plate mounts
Posted: Wed Sep 16, 2015 12:15 pm
by GT Wunder
Adam,
Not sure what i'ts from, but appears to be the same as my '66 Scrambler and '65 Bitza ( M3 frame). It is the best one I have, and they all look the same. I'm sure the Scrambler's is original as I'm the second owner and I bought it in '72 . I'ts not rusty, but has been repainted in the past.
George T.
Re: WTB: Side Stand 66 Scrambler(NC) and plate mounts
Posted: Wed Sep 16, 2015 4:56 pm
by Adam
Hi George
Yeah, it's been a challenge for this year. Many of the photos I've seen are taken of the right side of the bike. Must be the 'good' side!
Is that one for sale? If so, how much are you asking?
Thanks
Adam
Re: WTB: Side Stand 66 Scrambler(NC) and plate mounts
Posted: Thu Sep 17, 2015 1:02 am
by GT Wunder
Sent PM
Re: WTB: Side Stand 66 Scrambler(NC) and plate mounts
Posted: Fri Sep 18, 2015 3:47 am
by Adam
Hi George
Just checking. Did you get my PMs?
Adam