Page 1 of 1

Lots of parts for sale

Posted: Tue Oct 21, 2014 2:09 pm
by Ian B
I've just had to buy a van load of Ducati parts just to get a few of the bits I need. Included are several brand new Aprilia peaked headlamp rims for 150mm glass.
_MG_8827.jpg


_MG_8828.jpg



There is also a new exhaust Y piece for an Elite with twin silencers. It has a few tiny marks from sitting about for the last 30 years but is otherwise ready to use.
_MG_8829.jpg


Amongst the other parts are several cylinders including (I'm told) a brand new 450 cylinder, a 200 cylinder and a 250 cylinder. None have broken fins or any signs of bore wear.
There are also a pair of Monza/Sebring square type mudguards, a couple of square (hexagon) style headlamp shells, a Mach1 style headlamp shell and a smaller, maybe 175-200 headlamp shell. There's also a 'rough but repairable' Mach 1 rear mudguard. There is a new gear shaft and kickstart gear which i think maybe 175-200 as it's not the same as either my 250 4 or 5 speed! I've also most parts for 4 and 5 speed 250/350 n/c gearboxes.
I need to get some of my money back for this lot so if no-one on here wants it, it will go on ebay next weekend. Let me know if you want photos of any of the parts.. Open to reasonable offers.

Re: Lots of parts for sale

Posted: Sun Oct 26, 2014 3:30 pm
by Ian B
The Mach 1 (I'm told) rear mudguard described as repairable..

_MG_8840.jpg

_MG_8841.jpg

_MG_8842.jpg

_MG_8844.jpg

Re: Lots of parts for sale

Posted: Mon Oct 27, 2014 2:52 am
by JimF
How much for a peaked rim?

Re: Lots of parts for sale

Posted: Wed Nov 05, 2014 2:00 pm
by a_kress
Ian B wrote:There is a new gear shaft and kickstart gear which i think maybe 175-200 as it's not the same as either my 250 4 or 5 speed! I've also most parts for 4 and 5 speed 250/350 n/c gearboxes.
I need to get some of my money back for this lot so if no-one on here wants it, it will go on ebay next weekend. Let me know if you want photos of any of the parts.. Open to reasonable offers.



I'm looking for some parts for a 4 speed transmission for a 250nc. Specifically 4th gear. Would you part with just one gear or what do you want for the whole thing?

If you'd like to email me.. akress@akress.com

Thanks!

Re: Lots of parts for sale

Posted: Fri Nov 21, 2014 7:22 am
by cooperplace
would there be a swing arm for a 1975 350 desmo?

Re: Lots of parts for sale

Posted: Sat Nov 22, 2014 4:15 pm
by Ian B
cooperplace wrote:would there be a swing arm for a 1975 350 desmo?


Sadly not!

Ian

Re: Lots of parts for sale

Posted: Sun Nov 30, 2014 6:48 am
by Octane
My Mach 1 rear fender has broken in exactly the same way (after the tail light bracket let go. I was going to try and find a replacement but I think I'll try to repair it myself instead. It's far more salvageable than the one you've posted which gives me hope :P

Image

Sadly even the plate cracked again 50kms after it was repaired.