For Sale: Ducati narrow case engine stand adapter
Posted: Wed Jul 23, 2014 10:36 pm
by SP3
custom made by me many years ago. it should fit nearly any of the chinese made automotive stands made in the last 30 years. dimensions to be added shortly to this advert.
$75 plus shipping.
Re: For Sale: Ducati narrow case engine stand adapter
Posted: Thu Jul 24, 2014 10:50 pm
by SP3
here are some dimensions to determine if it will work with your stand:
-spindle diameter = 61.25mm
-spindle length A = 141mm from the back edge of the plates to the front edge of the handle holes
-handle holes diameter = 22.4mm
-spindle length B = 70.6mm from the back edge of the plates to the center of the lock pin holes
-lock pin hole diameter = 14.2mm (three 120° apart)
notes: when I made this, I had to grind out the weld inside the stand's head tube. two reasons; 1 - to make it as round as possible and 2 - because it would have chewed the adapter to bits (aluminum). granted, this was never used extensively but, a Duc single doesn't weigh much. It worked great for what I needed and spun around easily.
Re: For Sale: Ducati narrow case engine stand adapter
Posted: Sun Oct 18, 2015 12:47 pm
by SP3
SOLD.