Motoscrubs.com

I am just getting started on a 160 resto. I bought a used set of hubs and rims to temporarily replace the totally rusted set of rims that came on my bike. I started polishing the front hub and realized the cooling vents are no more effective than those on my dad's '63 Buick. Can I take a dremel and cut a slit where the faux vent exits, basically open it up to let air to flow in? I probably won't be riding the bike hard enough to need it, but it seems silly to have a faux vent when it would be easy to make it real.

Doing it neatly is the challenge.
When it rains, you might wish you could close it up again.

Jordan

http://www.mts.net/~jkrocker/Duke1/

This fellow did a nice job. It's at the bottom of his page.

Jim

Remember, you have do both to get air flow.