Page 1 of 1
In the clutch
Posted: Thu Mar 11, 2021 11:38 pm
by Romomoto
Anyone know where in the USA I can get a tool to hold the clutch hub on my 250? Or a steel plate I can use to make one?
Re: In the clutch
Posted: Fri Mar 12, 2021 5:48 pm
by double diamond
Send me a PM regarding clutch tool. I have one of these left.
image.jpg
Re: In the clutch
Posted: Sun Mar 14, 2021 5:07 am
by Gianni
Somewhere I acquired a clutch with the rounded hub, rather than cut square. Which bikes used this style engagement. Narrowcase?
Re: In the clutch
Posted: Sun Mar 14, 2021 5:35 pm
by double diamond
Cast iron basket installed on NC 250’s. Steel basket installed on NC 350 Sebring and all WC engines. The steel basket has a taller primary ratio
Re: In the clutch
Posted: Mon Mar 15, 2021 9:55 pm
by Romomoto
Double Diamond - thank you. I have come up with a clutch tool.