help finishing my 69 350 scrambler

[richrd]

this bike has been sitting in the shop for about ten years and I pull it out once every year or so to work on it. Now its time to finish it.

`first question, i started pulling out pieces for the primary and in with the clutch parts was a shim. it measures 24.95 od, 18.3 id and .5 thick. any one know where it goes?

the original coil terminals are marked "1" and "14". which would be + and which -, or does it matter?

And on the rest of the wiring, should I just run the wires I need like I would on British bike? or try to make sense out the mess that fits in the headlight?






thanks, and keep after me to finish this thing.

[cooperplace]

I don't know about the scrambler, but my 350 Vento has a shim like that on the gear change.

[Duccout]

Does it go behind the clutch?

[LaceyDucati]

The shim is off the kickstarter shaft and goes on after the piece of tube immediately up against the primary cover, last part on before the cover.

Regards Nigel

[richrd]

thanks. and I've decided to do my own wiring harness, and eliminate the mess in the headlite.