The oil strainer mesh housing is being difficult to remove from the external nut, any tips?
I can turn it a little by hand but can't remove it from the nut, had the brass nut in the vice and still cant pull the filer mesh out.
I bought a new nut as the brass original was well rounded.
Regards
250 single, remove oil strainer mesh
Moderator: ajleone
-
- Posts: 266
- Joined: Wed Feb 07, 2018 1:47 am
- Location: Edinburgh, Scotland UK
-
- Posts: 522
- Joined: Sun Sep 19, 2010 10:30 pm
- Location: Wales UK
- Contact:
Re: 250 single, remove oil strainer mesh
The original plastic filter is moulded into the brass nut and will be difficult to remove without breaking it. Your best bet (short of cutting the nut off) would be putting the whole thing in boiling water and trying to pull it off (wear gloves!).
Regards Nigel
Regards Nigel
-
- Posts: 266
- Joined: Wed Feb 07, 2018 1:47 am
- Location: Edinburgh, Scotland UK
Re: 250 single, remove oil strainer mesh
Thanks Nigel,
The strainer broke when trying to free it so I just ordered a new one from your shop today.
It split where it enters the nut, the remainder of the sleeve is still jammed inside the nut.
Regards
The strainer broke when trying to free it so I just ordered a new one from your shop today.
It split where it enters the nut, the remainder of the sleeve is still jammed inside the nut.
Regards
-
- Posts: 522
- Joined: Sun Sep 19, 2010 10:30 pm
- Location: Wales UK
- Contact:
Re: 250 single, remove oil strainer mesh
When you get the new one: Pour boiling water over the nut in the sink, dry it, then push the filter into the nut. The heat will soften the plastic slightly and make fitting much easier.
Nigel
Nigel
Return to “Ducati Singles Main Discussions (& How to Join)”
Who is online
Users browsing this forum: No registered users and 45 guests