Page 1 of 1
'66 250 frame - is this correct?
Posted: Sat Dec 15, 2018 9:46 pm
by kaysystems
Getting ready to have the frame blasted. I was looking at the mounts for the triangular toolboxes. Are the holes supposed to be different on each side?
j%iXMH9tQeG7Jk6R7EJKgA.jpg
YCB1LBzLSxGq4MTZ5aNWkw.jpg
Thanks
David
Re: '66 250 frame - is this correct?
Posted: Sat Dec 15, 2018 11:26 pm
by nalimugmug
Here is the correct tab
Re: '66 250 frame - is this correct?
Posted: Sun Dec 16, 2018 7:55 am
by Bevel bob
Really?,nothing like mine!.
Re: '66 250 frame - is this correct?
Posted: Sun Dec 16, 2018 9:34 am
by nalimugmug
Same bike with frame number
67.jpg
Re: '66 250 frame - is this correct?
Posted: Sun Dec 16, 2018 1:28 pm
by ranton_rambler
DSCF6055small.jpg
This is what's on mine (1961 175TS). Looks to be the same both sides.
Ian
Re: '66 250 frame - is this correct?
Posted: Sun Dec 16, 2018 2:02 pm
by Bevel bob
Thats more like it, I had to pack my mounts with washers to get the toolboxes to look right.
Re: '66 250 frame - is this correct?
Posted: Sun Dec 16, 2018 3:46 pm
by kaysystems
Thanks folks. I'll get the big hole welded up to be the same on both sides.
David