Mach1 engine stamp

Ducati single cylinder motorcycle questions and discussions, all models. Ducati single cylinder motorcycle-related content only! Email subscription available.
Moderator: Morpheus

Moderator: ajleone

my66m3
Posts: 2
Joined: Fri Nov 16, 2018 12:37 am

Re: Mach1 engine stamp

Postby my66m3 » Fri Nov 16, 2018 5:10 pm

I remember that in 1965 Americans Mark3's came with rear sets including the curved kick starter. My 1966 that I have had since new, I unrated it, has the frame mounting points for the rear sets the same as 1965. I also have another frame with them. My local dealer told me he had seen the Mach 1 at Berliner but didn't order any because they didn't come with the tach like the Mark 3. I hope this adds a little more background info.

flynbulldog
Posts: 75
Joined: Sun Feb 05, 2012 2:38 am

Re: Mach1 engine stamp

Postby flynbulldog » Sat Nov 17, 2018 3:13 pm

Wow I appreciate all of the info so far guys! Its all a little confusing; Mark3 and MarkIII were different bikes or at least had differing configurations. My frame has the rearset lugs and brake cable tabs for the rear-sets and I just checked and it does have the brake cable tab for the standard footpeg and brake configuration as well. Does that mean my bike is likely a 67 Diana? and would it be a mark 3 or MarkIII? And BTW I do have the curved starter and all of the rear-set foot controls and clip-ons that came on the bike so this bike was originally equipped with rear-sets and clip-ons.

double diamond
Posts: 555
Joined: Thu Apr 28, 2011 1:20 am

Re: Mach1 engine stamp

Postby double diamond » Tue Nov 27, 2018 12:46 am

If it has an engine number over 100000 that would be the range of 1967. Any Mark 3 frame could have clipons/rearsets installed but the period Berliner brochure images did not show this configuration

Matt

Dmayhue72
Posts: 6
Joined: Fri Feb 07, 2020 2:49 am

Re: Mach1 engine stamp

Postby Dmayhue72 » Fri Feb 07, 2020 3:41 am

I just got a 1967 Ducati 250 scrambler. I have striped it to the frame. But I don’t know how to take off swing arm and forks. Any advice?

Bevel bob
Posts: 1042
Joined: Thu Apr 15, 2010 8:01 am
Location: Bromley Kent UK.

Re: Mach1 engine stamp

Postby Bevel bob » Fri Feb 07, 2020 10:40 am

You need to start your own thread to get the best response . I expect that's what you intended to do.


Return to “Ducati Singles Main Discussions (& How to Join)”

Who is online

Users browsing this forum: No registered users and 44 guests