More 250 strata probs

Ducati single cylinder motorcycle questions and discussions, all models. Ducati single cylinder motorcycle-related content only! Email subscription available.
Moderator: Morpheus

Moderator: ajleone

Dave L
Posts: 93
Joined: Mon May 14, 2018 10:31 am
Location: Mallorca

More 250 strata probs

Postby Dave L » Mon Oct 22, 2018 1:41 pm

Thanks for all the advice so far everyone,much appreciated.Next question! The speedo drive cover plate sits about 3mm inside the hub.Is there supposed to be a shim/washer sitting on the bearing inner race between these two parts? I can't find a washer with these dims(23 outer,15 inner and 3mm thick)

Ventodue
Posts: 952
Joined: Mon Mar 08, 2010 3:23 pm
Location: Montpellier, France

Re: More 250 strata probs

Postby Ventodue » Sat Nov 03, 2018 4:22 pm

I think Jon has already given you a good lead .... :)

"The Strada wheel with a drum brake is the same as an Italian Ducati single, so has the same bearings and spacers etc. "

And so, following that lead, here is the parts diagram for the 250 Monza (and pretty much everything else, frankly). You'll see there are two washers, one felt (#620), one steel (#77.210). (If you've got sealed bearings, you can forget the felt one).

HTH

Craig
You do not have the required permissions to view the files attached to this post.
Last edited by Ventodue on Sat Nov 03, 2018 5:08 pm, edited 1 time in total.

Ventodue
Posts: 952
Joined: Mon Mar 08, 2010 3:23 pm
Location: Montpellier, France

Re: More 250 strata probs

Postby Ventodue » Sat Nov 03, 2018 5:05 pm

Dave L wrote:I can't find a washer with these dims(23 outer,15 inner and 3mm thick)


If you can't get one made - and I dunno where you are for postage etc - you could always try:

https://www.ebay.com/itm/DUCATI-BEVEL-V ... 0937141374

Listed with the correct part number (0170 77 210) at least ....


Return to “Ducati Singles Main Discussions (& How to Join)”

Who is online

Users browsing this forum: No registered users and 43 guests