More 250 strata probs

Ducati single cylinder motorcycle questions and discussions, all models. Ducati single cylinder motorcycle-related content only! Email subscription available.
Moderator: Morpheus

Moderator: ajleone

Dave L
Posts: 12
Joined: Mon May 14, 2018 10:31 am

More 250 strata probs

Postby Dave L » Mon Oct 22, 2018 1:41 pm

Thanks for all the advice so far everyone,much appreciated.Next question! The speedo drive cover plate sits about 3mm inside the hub.Is there supposed to be a shim/washer sitting on the bearing inner race between these two parts? I can't find a washer with these dims(23 outer,15 inner and 3mm thick)

Ventodue
Posts: 474
Joined: Mon Mar 08, 2010 3:23 pm
Location: Montpellier, France

Re: More 250 strata probs

Postby Ventodue » Sat Nov 03, 2018 4:22 pm

I think Jon has already given you a good lead .... :)

"The Strada wheel with a drum brake is the same as an Italian Ducati single, so has the same bearings and spacers etc. "

And so, following that lead, here is the parts diagram for the 250 Monza (and pretty much everything else, frankly). You'll see there are two washers, one felt (#620), one steel (#77.210). (If you've got sealed bearings, you can forget the felt one).

HTH

Craig
Attachments
Wheel.jpg
Last edited by Ventodue on Sat Nov 03, 2018 5:08 pm, edited 1 time in total.

Ventodue
Posts: 474
Joined: Mon Mar 08, 2010 3:23 pm
Location: Montpellier, France

Re: More 250 strata probs

Postby Ventodue » Sat Nov 03, 2018 5:05 pm

Dave L wrote:I can't find a washer with these dims(23 outer,15 inner and 3mm thick)


If you can't get one made - and I dunno where you are for postage etc - you could always try:

https://www.ebay.com/itm/DUCATI-BEVEL-V ... 0937141374

Listed with the correct part number (0170 77 210) at least ....


Return to “Ducati Singles Main Discussions (& How to Join)”

Who is online

Users browsing this forum: No registered users and 22 guests