Narrowcase clutch pushrod
Posted: Sun Aug 26, 2018 4:05 pm
Anyone know the correct length of the clutch pushrod assembly in a narrowcase 175?
This bit was all bagged-up when I got mine, and now that I'm putting it back together, it seems too long.
There are 3 sections of rod, whereas the parts book shows 2 sections, plus 2 balls.
With the clutch centre screw adjusted to 3mm as the book says, the selector box won't fit on, as the clutch arm hits it.
With the clutch arm positioned to let the selector box fit, the centre screw is only about 2 threads into the cover.
I have some balls I can use (same as head bearings I think) but I will then have a little piece of rod left over!
This bit was all bagged-up when I got mine, and now that I'm putting it back together, it seems too long.
There are 3 sections of rod, whereas the parts book shows 2 sections, plus 2 balls.
With the clutch centre screw adjusted to 3mm as the book says, the selector box won't fit on, as the clutch arm hits it.
With the clutch arm positioned to let the selector box fit, the centre screw is only about 2 threads into the cover.
I have some balls I can use (same as head bearings I think) but I will then have a little piece of rod left over!