Monza front wheel asssembly
Posted: Tue Mar 13, 2018 9:10 pm
OK so now I have an idea on how much torque to use on the nut.
After assembly I have a slight gap between the fork and the speedo side end cover.
I know it's wrong. The wheel is free, the brake works, if I loosen the axle nut I can slide the whole works back and forth so it's not binding up.
Yes I had the whole guts out to clean and repack the bearings and it all went back in the same order as removal.
Did I not get the bearings in the right spots ? I made sure they didn't pinch the spacer bar in between.
I'm at a bit of a loss on this.
This whole project is one forward and two back.
Any thoughts or help is most welcome.
Thanks.
Mike
After assembly I have a slight gap between the fork and the speedo side end cover.
I know it's wrong. The wheel is free, the brake works, if I loosen the axle nut I can slide the whole works back and forth so it's not binding up.
Yes I had the whole guts out to clean and repack the bearings and it all went back in the same order as removal.
Did I not get the bearings in the right spots ? I made sure they didn't pinch the spacer bar in between.
I'm at a bit of a loss on this.
This whole project is one forward and two back.
Any thoughts or help is most welcome.
Thanks.
Mike