Looking for 265 Needle Jet

[Vintmoto]

Hey Singles Fans,

I am rebuilding a SSI 29d carb and need a 265 Needle Jet that is not worn. If anyone knows where I might be able to locate one, I am willing to pay or trade for it.

Thanks in advance,

Ken

[ducwiz]

Have you checked here?
https://www.dellorto.co.uk/shop/dellorto-motorcycle-carburettors-parts/carburettor-parts/jets-needles-floats-calibrated-parts/1805-atomiser-ss1-type/

[Vintmoto]

They list it as unavailable unless it is because I am in the USA. If someone in Europe could check it it shows stock availble, that would be great. I would be happy to pay someone to purchase it and forward it on to me if it is in deed available.

[Ventodue]

Guzzino?

Guzzino.jpg

http://guzzino.com/dessineje18.html

[Vintmoto]

Buzzing only had 270s available. Not sure how much of a difference the step up in size would be. If anyone has more expience with this I would love to hear their insight. I am assuming my 265 Needle jet is worn since the needle showed obvious signs of wear. Which I knew how to measure it to see how far out it really is.

[Jordan]

Normal fix for a slightly worn needle jet is to lower the jet needle to compensate.

[Bevel bob]

I use a 260 and find it to work well in a Tuned 250 Mark3 NC ,and I still get symptoms of richness .

[Vintmoto]

I suspect going smaller would be fine as well as my bike always ran a litttle rich with the 265 also. Well if anyone has a 260 they would part with, I would be happy with one of those as well.

[Bevel bob]

Got my 260 from Australia. I did notice that it has no air bleed hole, I dumped the 265 so it would be helpfull if you could look at your 265 and give measurements for it?, I could try drilling the 260, if it does not help I will just solder it back up.

[Vintmoto]

Seems it would be a good opportunity for someone to have some made up. Seems like it would be pretty easy. I may look into it once I get a little more time.