Page 1 of 1
4-speed 250 Mark 3 tach holder
Posted: Sat Apr 29, 2017 9:13 pm
by ajleone
Anyone have a template for the Veglia tach holder for a Diana Mark 3? This is the one that is centered between the fork tubes, that was on the 4-speed Mark 3 and I believe similar to the F3. Thanks.
Tony
Re: 4-speed 250 Mark 3 tach holder
Posted: Sun Apr 30, 2017 11:21 am
by KarstenH
Hello Tony,
please look at
viewtopic.php?f=3&t=1475&p=11814&hilit=tach+bracket#p11814there are some drawings and fotos - i have made a sketch with icad - but im not sure about the masses from the holes for the fork tubes and the axial distance from this holes.
Regards Karsten
Re: 4-speed 250 Mark 3 tach holder
Posted: Sun Apr 30, 2017 5:05 pm
by ajleone
Thanks Karsten. I'll see if I can make a couple of these. I'll have to eyeball it, but I am sur I can get close.
Tony
Re: 4-speed 250 Mark 3 tach holder
Posted: Mon May 01, 2017 6:12 am
by KarstenH
Hello Tony
my sketch...
I need the exactly red masses - then i can correct my drawing.
Tacho Bracket.jpg
Regards Karsten