Anyone have a template for the Veglia tach holder for a Diana Mark 3? This is the one that is centered between the fork tubes, that was on the 4-speed Mark 3 and I believe similar to the F3. Thanks.
Tony
4-speed 250 Mark 3 tach holder
Moderator: ajleone
-
ajleone
- Posts: 230
- Joined: Sat Oct 31, 2009 11:20 pm
- Location: Pittsford, NY
- Contact:
-
KarstenH
- Posts: 71
- Joined: Sun Nov 20, 2011 5:44 pm
Re: 4-speed 250 Mark 3 tach holder
Hello Tony,
please look at
viewtopic.php?f=3&t=1475&p=11814&hilit=tach+bracket#p11814
there are some drawings and fotos - i have made a sketch with icad - but im not sure about the masses from the holes for the fork tubes and the axial distance from this holes.
Regards Karsten
please look at
viewtopic.php?f=3&t=1475&p=11814&hilit=tach+bracket#p11814
there are some drawings and fotos - i have made a sketch with icad - but im not sure about the masses from the holes for the fork tubes and the axial distance from this holes.
Regards Karsten
-
ajleone
- Posts: 230
- Joined: Sat Oct 31, 2009 11:20 pm
- Location: Pittsford, NY
- Contact:
Re: 4-speed 250 Mark 3 tach holder
Thanks Karsten. I'll see if I can make a couple of these. I'll have to eyeball it, but I am sur I can get close.
Tony
Tony
-
KarstenH
- Posts: 71
- Joined: Sun Nov 20, 2011 5:44 pm
Re: 4-speed 250 Mark 3 tach holder
Hello Tony
my sketch...
I need the exactly red masses - then i can correct my drawing.
Regards Karsten
my sketch...
I need the exactly red masses - then i can correct my drawing.
Regards Karsten
You do not have the required permissions to view the files attached to this post.
Return to “Ducati Singles Main Discussions (& How to Join)”
Who is online
Users browsing this forum: No registered users and 67 guests