lower bevel tower extractor

[kalli]

good morning all,

i have searched but can not find it, can you please tell me the dimensions of the (factory tool ) extractor required to remove the lower bevel tower.

thread size pitch (where it screws in the tower)
tread size for the rest of the rod if diferent that the above
inner part, threaded rod lenght
outer part spacer OD, ID, lenght

can not locate it so i intent to make it, any pointers or comments are welcome

thanks
kalli

[Rick]

extractor.jpg

The lower thread is 37x1, upper is 37x2
Threaded plug is 95mm tall
Collar is 60mm tall

If you included your location- even which continent- someone nearby might loan you the tool

Rick

[joe46ho]

Ian Gowanloch Should have an oem tool available to sell... I bought mine from him last year, and at the time he had several...

Joe

[machten]

Don't know where you are, but I have the original factory tool in Western Australia if that is any help. If you are not in Australia, probably not much help.

Kev

[kalli]

thanks for all the info guys and Kev thanks for the very kind offer, i am based in Greece and i think i am going to have a long term relationship with the tool since i am still striping my engine iand it will be a while untill it goes back together.
how do we get in touch with ian gowanloch, under what name is he running his ebay shop?

thanks for the help
kalli

[Sam]

This guy sells them I think for around about £30 email him and he will post one up on fleabay. http://www.ebay.co.uk/itm/ducati-single ... 4d29665546

[machten]

I think his ebay name is "italspares" from memory.

Kev

[kalli]

This guy sells them I think for around about £30 email him and he will post one up on fleabay. http://www.ebay.co.uk/itm/ducati-single ... 4d29665546

i did get the extractor and a flywheel puller from this seller, and i have to say good service indeed.