I want to remove the front wheel on my 250 scrambler circa (1968/69, not sure yet). I removed the nut on the clutch side of the front fork. Does the shaft pull out or do I have to remove the front fork? The shaft doesn't seem to move.
Any help is appreciated,
Art
Front Wheel removal
Moderator: ajleone
-
asmith411
- Posts: 35
- Joined: Wed Oct 01, 2014 11:36 pm
- Location: Philadelphia suburb
-
Eldert
- Posts: 772
- Joined: Sun Nov 01, 2009 3:23 pm
- Location: Hazerswoude Rijndijk Netherlands
Re: Front Wheel removal
Hi Art
did you undo the pinch bolt on the bottom of the other fork slider ?
Eldert
did you undo the pinch bolt on the bottom of the other fork slider ?
Eldert
-
DewCatTea-Bob
- Posts: 2897
- Joined: Sun Nov 01, 2009 10:53 am
- Location: Near SE side of Lake Michigan
Re: Front Wheel removal
[quote= asmith411 ...
" I want to remove the front wheel "
____ First, prop-up the front-end of the bike by resting the base of the motor on a milk-crate or the like,, then after you loosen the fork-leg's pinch-bolt, pull-out the axle and-then the entire wheel should drop-down & roll-out.
Duke-Cheers,
-Bob
" I want to remove the front wheel "
____ First, prop-up the front-end of the bike by resting the base of the motor on a milk-crate or the like,, then after you loosen the fork-leg's pinch-bolt, pull-out the axle and-then the entire wheel should drop-down & roll-out.
Duke-Cheers,
-Bob
PLEASE NOTE... If this-post is not-yet signed-off with '-Bob', then I'm still in the process of completing it,, and if not also included with 'DCT' near bottom as well, then I may edit this post's wording at a later time. - Dct.Bob
Return to “Ducati Singles Main Discussions (& How to Join)”
Who is online
Users browsing this forum: No registered users and 221 guests