Page 1 of 1
kickstart shaft washer needed
Posted: Sun Jun 15, 2014 12:00 am
by Carnaggio
Does anyone know where to find a kickstart shim for a 450 scrambler? Specifically, in mm, id,od,thickness = 22.1x27.5x0.5
The Ducati, classics site in England is non responsive. I have tried McMaster and other suppliers but the thickness and diameter are a difficult combination.
Thanks in advance for any help or direction.
Re: kickstart shaft washer needed
Posted: Sun Jun 15, 2014 4:49 pm
by LaceyDucati
You could always try us
http://www.laceyducati.comNot sure we have them new, until I can check tomorrow, but we would certainly have a good used one. Let me know if I can help.
Regards Nigel
Re: kickstart shaft washer needed
Posted: Mon Jun 16, 2014 6:19 pm
by ducwiz
Hi Ducatisti,
the german Seeger Company
http://www.seeger-orbis.com/products/shim-and-washers/shims/ manufactures not only circlips but also shim washers, in countless diameters, with different thicknesses. Here is a view of their shim catalog:
http://data.seeger-orbis.de/catalog/?page=103, 25x30x0.5 will certainly do the job.
Here in Germany, industrial suppliers selling SKF bearings often also stock the Seeger shims. Possibly, this applies also to the UK, US or AUS.
cheers Hans
Re: kickstart shaft washer needed
Posted: Mon Jun 16, 2014 11:23 pm
by Jordan
Thanks Hans,
At last I know why they call them Seeger rings in the Ducati manuals.
Re: kickstart shaft washer needed
Posted: Tue Jun 17, 2014 12:22 pm
by Carnaggio
Thanks Everyone,
NIgel, I will look online and let you know if I need additional help,
Ducwiz, that is a great resource, thanks
Jordan, good one. me too.