Motoscrubs.com

http://www.motoscrubs.com/MediaRSS_Gall ... CN1532.JPG


Does anyone sell reproduction brackets of this Veglia tach mount?


Jim

Jim, I had a few of these made up several years ago. Sold a few on ebay but if I have any left (pretty sure I do) I'll send you a pic and see if you're interested. I had them made in aluminum. The originals (at least, one I was shown that was supposed to be original) were thin sheet steel, so mine are not original specification in that respect. Matt

Hallo double diamond,

do you have a drawing from this brackets?
For my Diana project i wont to made such a bracket for a modern tacho.

Regards Karsten

Karsten,

I just made a tracing of an existing bracket and gave it to a sheet metal fabrication shop. Got the brackets back but not the tracing.

Regards, Matt

Hi Matt,

If you can find a bracket I am sure I will buy one.


Let me know.

Thanks

Jim

Hi Everyone,
I need one too....if anybody has access to a water jet/CNC these couldn't be hard to replicate. I have a rough drawing I traced off of one years ago, but it's just a pencil sketch on some yellow writing paper (should have taken it more seriously in retrospect!)

-Gabe Trench

Jim,

I found the brackets. I have several left. I've attached some pictures. $25 each plus whatever shipping works out to be (the brackets are pretty small so shipping shouldn't be much).

Gabe,

I can ship you one or bring one to El Camino, which will be here before we know it!

Matt

HI Matt,
I can wait until El Camino if you don't mind holding onto one for me. Thanks!!!
-Gabe

Sending PM

Matt,

Any of these brackets left?

Cam