Rev counter mount

[Eldert]

Hi Ian

what diameter is your rev counter ? if its 60 mm this holder might be a option

https://www.tomosmopedparts.nl/nl/produ ... moto-guzzi

Eldert

[ranton_rambler]

52mm.

I’m going to make something from a piece of aluminium alloy plate that I have.

[Jordan]

...

[Roland]

perhaps use a trailer hitch protection as housing?
Inside dia should be in range of your instrument.
https://www.obi.de/p/7380801/las-kupplu ... gI_svD_BwE

[Chewythekneeslider]

Hi there Ian,

Which cheap electronic rev counter did you go for? I might be interested in getting one for my little TS715 too.

[ranton_rambler]

Hi there Ian,

Which cheap electronic rev counter did you go for? I might be interested in getting one for my little TS715 too.

If the link works, I have this one -
https://www.ebay.co.uk/itm/198564117987 ... ame=111028

The same one is listed numerous times by different sellers. As you can see, it wasn't much money so I don't know how long it will survive.
Very few of the others I found seem to work on single cylinder engines.

[Roland]

use some rubber and zip ties along and the handlebares and it will work

[Chewythekneeslider]

Hi there Ian,

Which cheap electronic rev counter did you go for? I might be interested in getting one for my little TS715 too.

If the link works, I have this one -
https://www.ebay.co.uk/itm/198564117987 ... ame=111028

The same one is listed numerous times by different sellers. As you can see, it wasn't much money so I don't know how long it will survive.
Very few of the others I found seem to work on single cylinder engines.

Thanks for that, I've ordered one. I think that I might have a go at producing a mounting for it with CAD and my 3d printer.