Electrex World cdi box mounting

[Duccout]

Could be......

[Eldert]

Hi Graeme

that black box says 2 cylinder hall effect

Eldert

[Duccout]

Christ Eldert, we must call you Hawkeye.



Colin

[themoudie]

G'day Graeme,

I assume that you have ordered the "Hall Effect CDI Ignition System" from Nigel? Link below:-

Hall-effect-cdi-ignition-system-p-1459

You should note the following in red print, below the image and details of the product package:-

Please note the new CDI unit in this kit does NOT have a mounting point and therefore when fitting the unit will need to be secured to the frame gusset in some way, probably via a large tie wrap. We are working with Electrex for a solution with a small bracket but this may take some time. If you have any questions regarding mounting the unit please contact us.

That would appear to answer your question and confirm that a bit of closed cell foam and a couple of zip ties might have to serve temporary duties for the time being! Unless you fancy a wee bit of sheet alloy (road sign material), or stainless steel, flexing and bending from your repetoire of precision and "bush engineering"?

Good health, Bill

[graeme]

Hello Bill,

Ok I hadn’t seen that red note.
It’s not in the delivered paperwork.
I can sort a better solution than a cable tie.

Eldert,

I did notice the 2 cylinder marking on the CDI box.
Here is a pic of the kit I bought from Lacey Ducati.
It shows the same CDI box markings.

IMG_1810.jpeg

Regards
Graeme

[Duccout]

Ah, so all is explained......



Colin

[Dave354]

Hi, I have used a very high bond (vhb) double sided adhesive pad… here is the link:

https://www.ebay.co.uk/itm/254491435473 ... media=COPY

If both surfaces are grease free it sticks like the proverbial to an army blanket….. the ‘gel’ of the material also provides some vibration damping!

Just a suggestion.

Dave

[graeme]

Thank you Dave