Clutch Housing Bearings

[etsjw]

Does anyone have a good method for removing the two clutch housing bearings?
The manual drawing shows 2 bearing , 2 spacers, and a Seeger ring. This setup seems to make bearing removal a difficult task.
Thanks,
John

[Eldert]

Hi John

you can move the middle spacer over a little so that you can get a drift behind the bearing and knock it out .

Eldert

[etsjw]

Eldert,
The small inner spacer was stuck in the housing but once I freed it up I was able to move it around in the housing and knock the bearing out.
Used the same procedure on the other bearing by moving the Seeger ring around so I could use the drift on the large spacer.
Thanks much!
John