Clutch Housing Bearings

Ducati single cylinder motorcycle questions and discussions, all models. Ducati single cylinder motorcycle-related content only! Email subscription available.
Moderator: Morpheus

Moderator: ajleone

etsjw
Posts: 16
Joined: Wed Jul 19, 2017 2:05 am

Clutch Housing Bearings

Postby etsjw » Mon Dec 02, 2019 2:41 pm

Does anyone have a good method for removing the two clutch housing bearings?
The manual drawing shows 2 bearing , 2 spacers, and a Seeger ring. This setup seems to make bearing removal a difficult task.
Thanks,
John

Eldert
Posts: 610
Joined: Sun Nov 01, 2009 3:23 pm
Location: Hazerswoude Rijndijk Netherlands

Re: Clutch Housing Bearings

Postby Eldert » Mon Dec 02, 2019 3:15 pm

Hi John

you can move the middle spacer over a little so that you can get a drift behind the bearing and knock it out .

Eldert

etsjw
Posts: 16
Joined: Wed Jul 19, 2017 2:05 am

Re: Clutch Housing Bearings

Postby etsjw » Mon Dec 02, 2019 8:08 pm

Eldert,
The small inner spacer was stuck in the housing but once I freed it up I was able to move it around in the housing and knock the bearing out.
Used the same procedure on the other bearing by moving the Seeger ring around so I could use the drift on the large spacer.
Thanks much!
John


Return to “Ducati Singles Main Discussions (& How to Join)”

Who is online

Users browsing this forum: No registered users and 1 guest