Falcon 50/Sport 50 engine assembly

Moderator: ajleone

ajleone
Posts: 230
Joined: Sat Oct 31, 2009 11:20 pm
Location: Pittsford, NY
Contact:

Falcon 50/Sport 50 engine assembly

Postby ajleone » Sat Feb 23, 2013 9:38 pm

The Falcon/Sport 50 engines have loose roller bearings on both engine halves. one side of the clutch/gear shaft and the other on the drive gear shaft. I was going to assemble one side with the bearings and then hope the grease hold the other half whilst I jiggle it into place. Is there another technique ?
Any thoughts/insight would be appreciated.
Tony

grapes
Posts: 17
Joined: Sat Oct 16, 2010 2:47 am

Re: Falcon 50/Sport 50 engine assembly

Postby grapes » Thu May 09, 2013 3:02 am

I grease the bearings,then I use the smallest rubber band to hold them in place till cases are in place.hot oil will dissolve the rubber band in time.


Return to “2-Stroke Ducatis”

Who is online

Users browsing this forum: No registered users and 8 guests